" C " SHIFT

 I vacuumed out all the oil pans & emptied all the oil catch bottles. Also cleaned up oil on MP-21.

 

Emptied oil vac.

 

MP-12   Eye wasn’t reading on eagle fan tester; also the air bladder was popping out of the fan when it inflated.  I adjusted the eye & cleaned the bladder

            with alcohol. Working OK.

 

Mark is ordering more hydraulic fluid & some more ½”  female quick connects to install on maifolds for the oil vac.

 

 

    R. UPCHURCH

    MOLDING MAINT.

" C " SHIFT

MP-20    Blow back -  Removed & replaced two nozzle heaters.

 

MP-21   Grinder quit.  Wire came loose from E-Stop.

 

MP-17 Oil running on floor again- jug filled up. Cleaned up. Oil tank was empty. I filled it.

 

 

 

 R. Upchurch

Molding Maint.

4.19.10 D shift

Mp#1- made 4 ejector bars per Bill Potters Request at 16- 3/4" each.
Also finished connecting front water manifold hoses on it.

Repaired the wheel press for the baseplates, it had a sensor out of adjustment and another sensor completely loose. Checked operation and moved back onto floor.

Dryer# 17-alarmed and went into shutdown mode. It did it because it was set-up in the diagnosis pages to fatal out in an overtemp condition. Simply reset it after checking it over, filters, motor operation, contactors, etc. No further problems the rest of the shift.

Hot Stamp press on #12- the process technician (Roy Smith) asked me to assist him in setting it up as he was having difficulty. We got it going after much adjustment. I recommended that using set-up sheets would help him in the future.

Ronnie and I looked over the new Press 1 and discussed lubrication, when the machine manual comes in I would like to have a look at it. I hear Nissei went up on the price of manuals now?

Reminder, I will be out on PTO Tonight as well as next week on Thursday.

Call if there are any questions.

Sean

4/17/10

Replaced the conveyor belt relay in number 4 robot

Worked on the loader on MP22. Had to adjust the sensor and the load timers

Work the rest of the night on number 8 robot. The round back stop on the EOAT broke one of the guides off. I modified another one and got it running again finally.

Collin