Mp#2- Power supply in 486 controller quit working. I put the one out of press#4 in it and it has been running fine. The one from MRO did not work. I also tried it in#4 and it did not work either, the 12v shuts down after a few minutes with power applied to it.
GR#1 - replaced the rotating knives and the bed knives. Checked operation at press #5, O.K. to run.
The auxilliary hydraulic core unit for MP#1 got really hot so I shut it down to cool off, Mark is looking for the schematics for it, likely something is not relieving properly.
Sean
