Worked on the Milacron dryer again, I found a loose connection on the control board, one of the IC chips was not seated very well. Reconnected and ran for a few hours without further problems.
Have a great day.
Sean
Sunday, July 31, 2011
7.30.11 D-shift ...Sean
Mp#3- FHD current #1 alarm, found pump overload tripped, reset it and checked operation.
Mp#10- Nut press was not vibrating. Found sensor on RH side is bad, lens on it appears to be etched from solvent and will not focus now. I could not locate a replacement in MRO, so we may need to order a new one. Tricked it out so that it will still run from the LH side only. Posted a reminder on the PM board also.
Continued with PM.
MP#1- still running, will install the temp switch in the tank on auxilliary hydraulic power unit when it goes down next. I posted a reminder on the PM board in case A or B shift catch it down next.
Call if there are any questions. Have a nice day.
Sean
Mp#10- Nut press was not vibrating. Found sensor on RH side is bad, lens on it appears to be etched from solvent and will not focus now. I could not locate a replacement in MRO, so we may need to order a new one. Tricked it out so that it will still run from the LH side only. Posted a reminder on the PM board also.
Continued with PM.
MP#1- still running, will install the temp switch in the tank on auxilliary hydraulic power unit when it goes down next. I posted a reminder on the PM board in case A or B shift catch it down next.
Call if there are any questions. Have a nice day.
Sean
Subscribe to:
Posts (Atom)