Continued with PM's.
Rebuilt several of the heat guns tonight.
Cleaned out all the water strainers on the presses. They were not as bad as usual this time.
Added some oil to MP#8 about 15 gallons. It appeared there had been a leak on the machine. I cleaned up the oil around the clamp and beside the press when they shut it down.
Have a nice day!
Sean
Thursday, September 15, 2011
Sunday, September 11, 2011
Mp#4- Error 00047 problem.
For some reason the machine is rebooting and stopping in level 1. When powered down it usually comes up alright. Tonight I looked into it and found a red LED fault on slot 5 output card. After checking everything in the circuit, I found no problem with it, it just will not clear. That turned out to be unrelated to the more immediate problem. For that I tried the power supply that was in MRO and it DID NOT WORK at all. So, I put the old one back in. It has not stopped anymore in the last 9 hours it has been running so it may have been a loose connection in the power supply or card cage.??
Continued with #15 , finished drilling the holes on the stationary platen, got all but 10 tapped (by hand was the fast apparent way). Will continue on further tonight.
Have a great day.
Sean
For some reason the machine is rebooting and stopping in level 1. When powered down it usually comes up alright. Tonight I looked into it and found a red LED fault on slot 5 output card. After checking everything in the circuit, I found no problem with it, it just will not clear. That turned out to be unrelated to the more immediate problem. For that I tried the power supply that was in MRO and it DID NOT WORK at all. So, I put the old one back in. It has not stopped anymore in the last 9 hours it has been running so it may have been a loose connection in the power supply or card cage.??
Continued with #15 , finished drilling the holes on the stationary platen, got all but 10 tapped (by hand was the fast apparent way). Will continue on further tonight.
Have a great day.
Sean
Subscribe to:
Posts (Atom)