MP-24 Oil leaking from tank hatch, where the parts bin track is mounted. Replaced mounting bracket & tightened back down.
Surge bin 2 was clogged. Took line apart outside where it 90’s up. Vacuumed out line all the way back to silo. Readjusted flow tube. OK for now.
MP-4 Set up the timer for core 2 & installed a new bolt for one missing from the bottom core 2 cylinder.
Trying to locate & tighten some of the fitting leaks.
R.Upchurch
Molding Maint.
Got Hopper w/ sensor and Jet Loader installed for MP26
Added the color port for MP26
Installed stainless 90s, new hose, and clamps above the surge bins for plastic load lines
Freed up valve under surge bin 1
Ordered wands for grinders, short and long. Will be ready for pick up May 7, 2010
Installed the ladder for the feeder bowl on MP10
Replaced busted 480VAC plug on grinder on MP2
Ordered the mistakeproofing sensors for hole in baseplates (Wheel Press)
Ordered 3” Round Black Delrin
Picked up 5/8-11 X 4” SHCS for mold setter
Mark McKee
Technical Specialist
Oreck Manufacturing Company
mmckee@oreck.com
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7851
Put the barrel shroud back on MP1 after a bleed off
Core 2 pull quit reading in MP4. the bottom sensor wasn't working. I found another used sensor which would work with a magnet but not on the cylinder. The original senor started working again after I put a magnet to it. It quit one more during the shift so I removed it and stuck the magnet to it again to get it working. I don't know if there are any of these sensors it stock somewhere.
Cleaned the filters in the loader on MP23
Collin
