Mp#4- Repaired the oil leak on the Filter. Had to replace o-ring on fitting and sealed up with indian head. Checked for leaks, O.K. to run.
Mp#5- Robot has stopped a once over the conveyor. Has not stopped since I adjusted speeds.
Continued with PM's and helped with processing some. Most of the presses that needed PM'd were running but worked on what was down. This has been reflective of the past few months.
Have a good weekend. Give me a call ...
Sean
Friday, September 30, 2011
Monday, September 26, 2011
9.24-25.11 Weekend...D-shift
Continued with PM's.
I noticed that many of the C-axis parts on the AEC robots have reached a point where they need rebuilt.
I looked up the components in the book that will need replaced and found the website and number to get a quote. I would recommend getting (6-10) each to begin replacing them and make them stock items until we replace the robots.
Additionally, we should consider the option of setting up a "rebuild kit" for the Y-axis arms. We could take the Y-arms down, replace bearings, belt, and aluminum extrusions as needed.
We could begin with (1) "kit" and try to trickle them in one a month or so?...Just a thought.
Here is the link to the AEC website where the parts number is, etc.
I left a copy of the part numbers and diagram on Joshs' desk.
http://www.aecinternet.com/index.cfm/datakey/3/category/Parts%20%26%20Service/subcategory/Parts/productID/1632.html
Also, had some trouble with the nutpress on #10 LH side. I ended up cutting more clearance in the small cover plate so they could pass through easier. It has ran great since.
MP#1- I noticed the ejector axis servo drive belt is damaged. It is still functional, but needs replaced.
Since we had that trouble with the belt on the clamp axis we may want to either schedule Nissei in to look at them both or order the belts, etc?
Give me a call if there are any questions, or leave me a blog so I will know what's been going on.
I never heard if the static charger was bad or what was done to resolve the issue Gary mentioned last Wednesday?
Thanks,
Sean
I noticed that many of the C-axis parts on the AEC robots have reached a point where they need rebuilt.
I looked up the components in the book that will need replaced and found the website and number to get a quote. I would recommend getting (6-10) each to begin replacing them and make them stock items until we replace the robots.
Additionally, we should consider the option of setting up a "rebuild kit" for the Y-axis arms. We could take the Y-arms down, replace bearings, belt, and aluminum extrusions as needed.
We could begin with (1) "kit" and try to trickle them in one a month or so?...Just a thought.
Here is the link to the AEC website where the parts number is, etc.
I left a copy of the part numbers and diagram on Joshs' desk.
http://www.aecinternet.com/index.cfm/datakey/3/category/Parts%20%26%20Service/subcategory/Parts/productID/1632.html
Also, had some trouble with the nutpress on #10 LH side. I ended up cutting more clearance in the small cover plate so they could pass through easier. It has ran great since.
MP#1- I noticed the ejector axis servo drive belt is damaged. It is still functional, but needs replaced.
Since we had that trouble with the belt on the clamp axis we may want to either schedule Nissei in to look at them both or order the belts, etc?
Give me a call if there are any questions, or leave me a blog so I will know what's been going on.
I never heard if the static charger was bad or what was done to resolve the issue Gary mentioned last Wednesday?
Thanks,
Sean
Subscribe to:
Posts (Atom)