The nut feeder vibratory bowl is not working all the time it comes on from time to time with no LED indicators lit. It is outputting a voltage but no current. The LED's are showing both red and green off. When the nuts are loaded to the sensors, the green comes on indicating the sensors detect presence. I tried adjusting the sensitivity but it still cycles infrequently. I am going to look at testing the triac again. The vibration adjustment knob was maxxed out at 10 again also.
Mp#15- Drilled and tapped out 4 holes on the moving platen at Roger's request. Need to several others when the press is available.
Talk to you tomorrow!
Sean
Thursday, March 8, 2012
Sunday, March 4, 2012
3.2.12 Sean
MP#21- Is locked out. The key for my lock is on my toolbox. The ejectors were not working. I put a mold in it and clamped it up to set the clamp readout, etc. The ejectors worked once and started leaking from the hose I made. I replaced the fittings and the hose end and it did not leak anymore, but I still couldn't get them to move on their own. Probing the valve, it worked fine.It still needs zeroed out though.
I was looking for the procedure when I got the call to come home, my wife had spotted a tornado. Of course by now, everyone has likely seen the news about our area.
I came back in on Sunday and set the dryers and left them a note for start up.
Call if you have any questions.
Sean
I was looking for the procedure when I got the call to come home, my wife had spotted a tornado. Of course by now, everyone has likely seen the news about our area.
I came back in on Sunday and set the dryers and left them a note for start up.
Call if you have any questions.
Sean
Subscribe to:
Posts (Atom)