Mp#8- Replaced the ejector hydraulic hoses. They had been red tagged since 2008, so i replaced them and checked operation.
Continued working on PM's.
Need to order some cabinet fans again in 120VAC.
Have a great day!
Sean
Monday, December 20, 2010
Sunday, December 19, 2010
12.18.10 D shift - Sean
Continued with PM's...Presses and robots #2 and #4 tonight.
Had an issue with #23 ejector encoder was not reading right after they set a mold in it.
I changed the offset on the VRE encoder offset and it started working correctly. I did check to see if anything was loose on the encoder first but it appeared tight.
Sean
Had an issue with #23 ejector encoder was not reading right after they set a mold in it.
I changed the offset on the VRE encoder offset and it started working correctly. I did check to see if anything was loose on the encoder first but it appeared tight.
Sean
Subscribe to:
Posts (Atom)