Friday, May 11, 2012
5.11.12 -Sean Kearns
Did not get to work on the T-nuts tonight because:
Mp#1- screw problems. Machine was sucking back an inch before running the extruder motor. This was causing splay. I removed the panels and cleaned and regreased the ball screws and extruder. The decompression velocity was set to zero, in my experience if you at least put something on it, it tends to work. We had a problem once before where this was zero and putting a value in there fixed it. Should be ready to go, they did not want to run it the rest of our shift so keep an eye on it.
Mp#10- Nut press was acting sluggish. Cleaned, refilled the FRL oil. Started working good, no further problems this shift, may have a cylinder going bad. Keep an ear out for this.
Cleaned up some oil on #3 and plugged the remainder of holes.
Give a hollar if you have any questions. Have a great day!
Sean
Thursday, May 10, 2012
5.10.12 Sean Kearns
MP#10- Completed the ANSI audit.
MP#12- Completed the ANSI audit.
Mp#6- Replaced the regulator for the robot.
MP#3- Removed the hydraulic lines in preparation for pump removal.
Have a nice day!
Call if you have any questions!
Sean
MP#12- Completed the ANSI audit.
Mp#6- Replaced the regulator for the robot.
MP#3- Removed the hydraulic lines in preparation for pump removal.
Have a nice day!
Call if you have any questions!
Sean
Monday, May 7, 2012
5.7.12 Sean Kearns
Mp#14- I heard the extruder motor is likely shot? That a new press may be in our sights if we can find one for the right $?
Mp#10- The nut press was having some issues getting the left side to fit in correctly to where the sensor would read it. I dug out some nuts from up under the back stop and they fit better. It may still need some final finishing when they are not running it. It works if the operator will "work" with it some.
Mp#3- Completed the ANSI audit. I also had to go back over some of the purge sheild signs and re-fasten them with rivets. I will get to them all if I have enough rivets.
DR12 - A wire had come loose from the process heater contactor causing it not to heat correctly.
Put it back and checked operation, O.K. to run now.
I will continue working on the audits tomorrow and try to get them done this week!
*Only 10, 12, 14?, 15, 20, 21, 25, and 26 remain to be audited.
Have a very nice day!
Sean
Mp#10- The nut press was having some issues getting the left side to fit in correctly to where the sensor would read it. I dug out some nuts from up under the back stop and they fit better. It may still need some final finishing when they are not running it. It works if the operator will "work" with it some.
Mp#3- Completed the ANSI audit. I also had to go back over some of the purge sheild signs and re-fasten them with rivets. I will get to them all if I have enough rivets.
DR12 - A wire had come loose from the process heater contactor causing it not to heat correctly.
Put it back and checked operation, O.K. to run now.
I will continue working on the audits tomorrow and try to get them done this week!
*Only 10, 12, 14?, 15, 20, 21, 25, and 26 remain to be audited.
Have a very nice day!
Sean
Subscribe to:
Posts (Atom)