2-5-11 Mike Daniels

MP25 adjusted the part verify switch

 

Worked on PMs

 

Overall good night

Ronnie Upchurch

MP20  Replaced the ejector cylinder, end cap, piston rings, and seals.

 

MP-25  Installed a relay on the robot up stroke; to prevent the cycle from stopping when the grippers drop the sprue.

 

MP-5  Core 2 not reading pull. The switch on the bottom cylinder wasn’t making.

 

MP-19  Ordered a seal kit for the sled cylinder.

Good Morning Gents,

 

Worked on dryers most of the night got 3 of them working and moved them to mezz room.

Spent of the night cleaning and putting things in there place.

 

Mike Daniels

Technical Specialist

Oreck Manufacturing

1400 Salem Rd

Cookeville,  TN  38506

Cell 931.287.6252

 

Eat. Sleep. Fish.

 

Ronnie Upchurch

          1/29/2011

 

MP-11  Replaced missing switch levers on control panel.

MP-10  Added two more quick connects on air manifold. One 3/8” & one ½”.

D-32  on mezzanine wouldn’t restart—Bad process blower contactor—out of stock. I was going to swap with D26, but the process blower motor was locked up

         & had two blown fuses. I put a 100# per hour dryer in to get by---- no spare 200# .Had to wait till Sunday to pull the two dryers down & take to the shop

         to repair – “ No Overtime”

 

 

          1/30/2011

 

D-32  Need to order a contactor for this one. Old one is on desk.

D-26  I replaced the process blower unit.

MP-13  The ejector lost it position. I found the collar that the transducer read position from had fallen off. Re installed.

 

I am leaving early today, because I stayed over an hour last night.