May 9, 2011
Worked with
MP1 clamp making noise removed guards at the end of machine, found broken screws in motor gear, gear had slid, belt hanging off, removed broken screws, pulled gear back in place, tighten bolts, greased all fittings on that end, replaced guards, looks OK
Mark McKee
Technical Specialist
Oreck Manufacturing Company
mmckee@oreck.com
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7615
Replaced FHD board and pressure transducer on MP5.
Rebuilt sled cylinder on MP20.
Ran High Voltage lines on MP22 product arm. Provide means for easily
disconnecting EOAT on insert side.
Valves for Mezanine purge valves are on table.
Conair dryer push button touch pad is on table.
MP24 was faulted and would not clear the error. Ended up switching from
manual to auto and back and then reset cleared.
Mark McKee
Technical Specialist
Oreck Manufacturing Company
1400 Salem Rd
Cookeville, TN 38506
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7615
Mark McKee
Technical Specialist
Oreck Manufacturing Company
mmckee@oreck.com
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7615
