MP-11 I shut the press down & cleaned up oil on the clamp end. Found two leaks on eject. Manifold , tightened , & restarted press.
MP-16 Mold not closing – error 122 – not making eject. back switch . The eject. back jumper had a broken wire.
MP-17 Hose on eject. manifold sprung a leak. Made up a hose & replaced. I made a hose for the other side too, but I couldn”t find
any ½” boss fittings.
MP 6,7,8,10,11,& 12 Vacuumed oil pans Then emptied oil vac. I started on # 1 ; The vac . will probably need to be emptied again.
No comments:
Post a Comment