Ronnie Upchurch

1/25/11

 

MP-6-7-8   Vacuumed oil pans.

 

MP-5  The bolt on the “C” axis pivot backed out & it wasn’t making the limit switch every time. Repaired.

 

MP-6 The robot kept stopping when “Y” axis started in mold. I found that the “Z” axis was loosing position. I tightened the encoder shaft coupler. OK now.

 

MP-12  Novatec dryer was running hot- not enough air flow on return from hopper. Bill didn’t want to shut it down to check for blockage in hopper. “Run it till

            The wheels fall off !! “

 

1/25/11

 

MP-10  The wheel press wouldn’t reset without switching the power off. Mark reassigned a reset in the program. Nuts are still oily, & they still want to run

      A faster cycle, & wonder why they have trouble pressing parts that are shrinking too much, & then blame us for the press not having enough pressure-

      Same old – same old !

 

MP-9  Vacuumed oil pan.

 

MP-2  The robot “X” axis position kept changing. The encoder shaft coupler was loose & the plug tie down only had one screw in it & plug was half way out. Repaired.

 

MP-3  The nozzle heat was unstable. The tip heater didn’t have a clamp & the T.C. was loose. Installed clamp.

 

MP-6  The gate cutter index cylinder slide broke. Mark made new mounting plates. Gary had already replaced the other side. The press will probably start

         up on night shift. Check for set up before it starts.