Mp#25- Has been stopping for core bwd limit sensor. I found the core cylinder was loose. It has stopped a few more times infrequently. I have checked the wires on the switches and plugs. At this point I think the mold cores may be getting caught up and not pulling after it shoots parts.
It occurs about once every half hour, and always at the same place in the cycle, right before it starts to open and cores are pulling. I added some time before opening to it and it seemed to help.
Mp#14- The machine would shoot parts and then stop before building a shot again. Then the clamp would not open up in manual. Checked many switches, etc. Finally found the mold touch switch (LS2) was flickering. I re-adjusted it and checked operation, no further problems.
Continued with PM's..
Sean
No comments:
Post a Comment