Mp#1- Robot is down until pendant is available.
Nut Press on #10- Replaced a sensor on LH side square nut fixture. Cleaned and inspected it. O.K. to run.
Pm'd Press #5. We are putting loctite on the screws on all the loading receivers on the presses and in the mezzanine to prevent screws from loosening. I am also trying to get around and refill all of the FRL's with oil where needed on robots, etc.
Mp#6- Replaced the rpm tach for the extruder that was busted off. Used the one from MRO.
Have a nice day.
Sean
No comments:
Post a Comment