Mould-Tek Dryer on SB#1- The dyer has stopped in cycle due to the failed gear motor that burned out likely from the mechanical apparatus that ratchets the desiccant beds around. We need to order another gear motor for it. I found them in grainger for about $100. Also, the linkage in the ratchet apparatus needs to be checked out for corrct function, it was sloppy loose so I tightened it up and tried to manipulate it by hand but I was not certain about it. When the motor comes in we can check alignment and operation in further detail.
Mp#15- The mold setter evidently put too long of a screw in the platen holes that I recently tapped to 3/4". I asked Roger to get with him and decide what size screws we needed to accomodate setting molds correctly. Now it has a bolt stuck in it, they did not want to repair it, only set the new tool and run the press. So?
Give me a call if there are any questions.
Sean
No comments:
Post a Comment