Took apart and tapped three hydraulic cylinders on the new molds for 3/8" pipe thread. Only had time to put fittings on one cylinder.
Made a bracket for MP22 conveyer to keep hoses off it.
Worked on dual ratio valve on MP23. It wasn't loading regrind.
Wired a new heater and thermocouple on a mold that came in the shop.
Thermolater T31 tripped the motor overloads. The motor is bad and will not start. I got a new one from MRO and a pump seal kit but didn't have time to replace them. I'll try to get to it tonight.
Collin
"C" Shift
No comments:
Post a Comment