Worked some on the Eagle sole plate press controls, the main panel is wired and installed.
MP20, process tech had problem with new DME cables not fitting or clamping up right. They were six pin instead of five pin. We have both on the floor, but we only stock the six pin.
MP13 shut down, ends up the front door switch was not made. Use code 100 to find out.
Helped Elaine establish a healthy list of Robot EOA components and Josh ordered today from EMI.
Talked to EMI guys today about a quote for (3) Decline Conveyors for new machines.
Ordered two new hydraulic cylinders for one of the new molds. Ortman brand. Should be here in 4 days. They are prepped for Go switches.
Ordered more Omron micro switches for new molds.
Ordered (2) station junction boxes from Motion.
Worked on MP14 sub station. Replaced LH pneumatic PB on cord hook snap.
Loaded the truck headed for Zag with the Wittman Robot and Air Skates.
Mark
1/14/10
Mark McKee
Technical Specialist
Oreck Manufacturing Company
mmckee@oreck.com
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7851
No comments:
Post a Comment