Mp#5- fhd current input #1 exceeds limits alarm.
Changed the fhd current index for extruder max out value to 12000 from 16000. Per Josh's advice. No further issues this shift.
Mp#16- Used the heater band from #1 to get the heaters going on it. Noticed the sprue-break limit switch adjustment ring was slid back a little more than all the way up. This may have contributed to some bleeding off that occurred. Put a note on the press for operators to remind the techs each hour to check for bleed off.
Found a 400 ton FN7000 1999 model online last night. It had a 575volt.
http://www.usedplasticinjectionmoldingmachines.com/2010/02/04/1999-398-ton-used-nissei-injection-molding-machine/
Another one:
http://www.kitmondo.com/ViewListing.aspx?lid=242651&prodName=Nissei_FN7000
This is the 575 volt one:http://www.elitemachinerysystems.com/machine_details.php?prod_id=645
No comments:
Post a Comment