DR26- repaired the carousel position switch with new screws, no further problems with it.
Gr13- repaired hinge pin, made a new one.
Mp#3- screw was wrapped with plastic and it would not build consistent shot.(kept stopping). Jacked up the barrel heats to 550 and let it soak for about 45 minutes then ran a bunch of clear PC regrind purge and compound through it until it was shiny clean. Ran great the rest of the night.
Mp#2- was down so I checked the core 2 circuit, at first it would not work, then I moved the pressure line to the P1 circuit and it had 2000 psi. Checked it with the test rig that was in the shop and it worked fine. O.K. to run.
Also on 2, I cleaned up the oil that was in the floor there, I couldn't really tell where it was coming from, but it was under the mold area mostly and appeared to have dripped down... was there a leaky mold on A or B shift?
Started swapping orientation of the U-bolts on the disconnect signs, should be finished by this weekend.
Did we decide what to do with the 200volt conveyors in the shop? I can put them back in the trailer? Let me know.
Sean
No comments:
Post a Comment