Sunday, February 28, 2010

" C " SHIFT

MP-16  Tech said barrel heats were running too high.  I checked heaters, contacts, T.C. connections,& cables. Everything checked OK.  The heat profile was 500 to

       535. ( Nylon )   For some reason, we had to run the heats 50 to 55 degrees under & parts ran fine.

 

MP- 17  Mold 74005-01 broke a pin “ again “.  I found the thin switch had been wired N/C.  I changed it & Gill repaired the mold. It should be back in & running

       Before the end of the shift.

 

MP-21   I vacuumed up oil & cleaned around press.

 

DR-23  I put this dryer on the mezz. In place of  DR-19 . We need to order large bed gear for DR-19    Conair part #  183875

 

 

 

         R. Upchurch

         Molding Maint.  

No comments:

Post a Comment