Mp#25-
It is down and needs an encoder for the ejectors. They had problems with it after changing the mold and it would not read, I worked on it and got it to read but it would never close the clamp and it would give an alarm like: "confirm setting for ejector bwd limit." I wanted to eliminate that it was n't the limit switch cicuit so I checked the door switch, and ejector back limit switch jumper and cable.(was fine). I spoke with Mark and gave him the Encoder information and model number.
Made EOAT for the Edge top cover on #11.
Got the signs turned around for the Machine Disconnect locations.
I am sending an email to Jerome asking for some time to get leaks fixed on press# 17.
Call if there are any questions.
Sean
No comments:
Post a Comment