" C " Shift

• Wiped down & lubed all tie bars before start up. Made sure the chiller & pumps were operating.

 

MP-19  Replaced broken oiler fitting ;bottom  non – operator side.

 

MP-11  Robot not going to home position ; turned off main robot power & rebooted- OK

 

D-32 ( mezzanine )   Alarm 11 -  Adjusted index switch.

 

MP-9  Robot  Z  axis brake not releasing – checked all connections, & cleaned the contacts. Working fine now

 

MP-22  Tech burned his arm while purging out barrel. I checked to make sure we didn’t have a heater problem. The last shift that ran did a mold change &

           didn’t purge the barrel. They went from Santopren to nylon. When the new set up was loaded, it was 200 degrees higher

           than the new material being  loaded.

 

 

 

 R. Upchurch