" C " Shift

MP-9  Robot wasn’t homing;  the reference block had been moved & one of the home blocks was loose. I got that straightened out & then there was

          no vacuum on the cups. There was water in the system; bled it off & set the vac verify switch—ok to run.

 

MP-17  The nozzle heat controller was in hi - temp alarm & wouldn’t heat.  There was a loose T.C. connection at the controller—Repaired.

 

MP-12  The grinder was making a noise ;  I cleaned it out – the material was hot & just about to start melting. I let it cool down, & had to adjust the rear

           stationary blade. I reassembled the grinder & got them to turn up the regrind load time. OK to run.

 

 

 

 

  R.Upchurch