MP4, Zone 1 was running away, contactor stuck, replaced with new one.
MP15, Replace small shock absorber on crosswise for sprue picker. More are on order.
We received a spare pressure transducer for the Cincinati’s. It is on shelves to the left in MRO.
Helped
Ordered program change to include additional core sequence for MP25 from NIssei to EJECT before CORE pull.
Worked on MP21 inject side. Back Screw position was stopping short of desired location. Made adjustments to internal codes 32 and 33 to remedy.
I sent out procedure on previous log.
Talked with R Russell about Hoky wheel and hub press. Ordered 2 hand tie down and pilot operated valve for new station. Also ordered alum tabletop.
Working on setting up Vendor for Robot EOAT quick change plates. I tested the orings on the dovetail slide and they held at 80psi.
Filled out PR for Rapid Grinder components destroyed by grinding hot runners. It was rejected at this time due to lack of funds.
Ordered, received, installed new hooks and shackles for robot chain slings. They are located in the bottom of the gray cabinet in the shop labled Large Hand Tools.
Ordered fittings and bolt kit for core valve install on MP23.
Ordered and received Asco valves for Thermolators. They are located in MRO on the RH shelves above the alum load system fittings.
Started replacing the adjustable stop screws with winged handles on MP23 Robot. Some bolt hole patterns were to close for 2 handles. I will check with HIro for some different stops. More handles with longer bolts and metal handle are on order.
Any questions just give me a call,
Mark McKee
Technical Specialist
Oreck Manufacturing Company
mmckee@oreck.com
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7851
No comments:
Post a Comment