MP-5 Core 2 set switch not making. The mold wasn’t repaired over the weekend, so they had to pull it again for repair. Both switches were bad. Tooling
Replaced them.
MP-15 Lost all manual control function. I found that the mold hanger had over stroked clamp open while setting it up. Also the eject back switch wasn’t made.
I just had to make the switch & go through the clamp position reset procedure.
MP-20 Pre dryer loader not coming on. The load level sensor was out of adjustment.
MP-2 The front zone heat dropped out. The mercury contacts stuck open. “ Tap & Go”
DR-17 Regin over temp alarm. I found out they had just shut it down & moved it to another press without letting it cool down. After it sat & cooled awhile,
It started right up.
New Novatec dryer- Still under warranty. They are sending a new drive motor & speed control. We have to send the old motor & speed control back.
I got a quote for a Novatec loader to go on the Matsui dryer hopper. Waiting for Jerome.
No comments:
Post a Comment