MP-12 They had some more trouble with the injection encoder rail gear. I found a new gear in the L-1 cabinet. Mark installed it. I put some grease on the extruder
follower arm – it was squealin ! I’ll order some more of the rail gears.
MP-24 I hooked up an eject. back safety switch.
MP-21 I drained the oil tank & pulled the tank inlet strainers. They were both 90% clogged. I cleaned them in the parts washer & reinstalled. Josh wants to run
the static filter on it for awhile; because there’s still some sediment in the bottom. I cleaned out what I could reach with the oil vac.
MP-25 Cinn. Milacron dryer kept going into high temp. alarm. First I thought it was the mercury contactor sticking. It turned out to be a loose connection – the
process temp. probe at the board.
No comments:
Post a Comment