The conveyor in the shop needs a belt, I looked in MRO for another one but could not locate any.
I was able to find a pdf on the servo controllers/ servo motors in press# 22. There is some software available that assists in tuning and parameter adjustments of the drivers called Panaterm. There appeared to be some ways within the drivers to change response profiles on velocity and positions, etc. as well as look at actual values while it is running.
Since it did run fine all weekend without loosing position values , I would assume that this problem is, in fact, related to the static issue.?
Worked on PM's all weekend.
Mp#10 and #7. Painted on #7.
Installed the track sensor and adjusted operation for the connector nut press on #10. It is fit to run.
The overhead water pipes have been banging around all weekend, Jeremy and Ronnie were in here looking at them on saturday, my guess is that it is air in the lines? I told Roger to send out an email to Walter about it.
Have a nice day, call if there are any questions.
Sean
No comments:
Post a Comment