Mp#20- Put on a nozzle heater band.
Mp#1- They set a mold in the press that was too short for the daylight again. Roger requested that I make up some spacer bars to bolt onto the moving platen so it could be installed.
I drilled and marked them with "Caution" and put threaded 1/2" holes on top so they could be moved with lifting rings or eye bolts.
It was late before he got it set so I was only able to clean the outside of the press and around it .
I noticed the lube oil line is broken on the non-operator side skate and I could not locate any fittings with ferules for that tubing.
I did replace the grease tube and noticed that we are running very low on that grease, especially now that we have 2 presses, we should order some more for them.
Mp#10- replaced missing screws from the nut feeder tracks and unstuck a screw that had found its way into it.
Have a nice day.
Sean
No comments:
Post a Comment