Mp#15- Completed the ANSI audits, all machine have been inspected at this point. Let me know when you want to start proceeding with circuit changes, etc. I will watch for the presses to be down.
Mp#7- They are running the R2 baseplate subassembly there today and the feedback I am getting relates to a desire to have the light curtains installed and the press set up to run similar to the baseplate press on #6.
The job runs at 76 seconds now, which is kind of long, but the operators have to keep their fingers in the anti-tie down switches for the duration of the cycle (safety issue) which takes approx 7 seconds with each part x 2 cavs =14 seconds each cycle.
This may be as fast as they can run it under the circumstances? Not sure.
It may be a legitimate claim to ask for this modification, I just don't know if it justifies the expense?
I wanted to pass this on to you Josh and see what you think.
Shift change again. The 5 weeks trial is over after this week. Mike and I texted last night and he is ready to come back after memorial day on Wednesday.
He is taking off Friday and Tuesday and will return to 3rd's after that. Tonight the dryers were not set on timers and we had wet material on a few hoppers. Evidently he was out last Friday and no one set the timers so this needs to be looked at this week again. I can set them if no one else is going to. Let me know.
I will go back on 2nd's Tuesday evening as scheduled.
Have a nice day!
Sean
No comments:
Post a Comment