5.11.12 -Sean Kearns

Did not get to work on the T-nuts tonight because:

Mp#1- screw problems. Machine was sucking back an inch before running the extruder motor. This was causing splay. I removed the panels and cleaned and regreased the ball screws and extruder. The decompression velocity was set to zero, in my experience if you at least put something on it, it tends to work. We had a problem once before where this was zero and putting a value in there fixed it. Should be ready to go, they did not want to run it the rest of our shift so keep an eye on it.

Mp#10- Nut press was acting sluggish. Cleaned, refilled the FRL oil. Started working good, no further problems this shift, may have a cylinder going bad. Keep an ear out for this.

Cleaned up some oil on #3 and plugged the remainder of holes.

Give a hollar if you have any questions. Have a great day!

Sean