Mp#14- I heard the extruder motor is likely shot? That a new press may be in our sights if we can find one for the right $?
Mp#10- The nut press was having some issues getting the left side to fit in correctly to where the sensor would read it. I dug out some nuts from up under the back stop and they fit better. It may still need some final finishing when they are not running it. It works if the operator will "work" with it some.
Mp#3- Completed the ANSI audit. I also had to go back over some of the purge sheild signs and re-fasten them with rivets. I will get to them all if I have enough rivets.
DR12 - A wire had come loose from the process heater contactor causing it not to heat correctly.
Put it back and checked operation, O.K. to run now.
I will continue working on the audits tomorrow and try to get them done this week!
*Only 10, 12, 14?, 15, 20, 21, 25, and 26 remain to be audited.
Have a very nice day!
Sean
No comments:
Post a Comment