Mp#10- Put the jumper on wire no.224. That cleared the problem with the cores not working- after I removed the jumper and turned cores back on.
I do not know why, but evidently 224 needs to be jumpered on that press with 69 -vdc.
The ejctors were still acting eratic and the mold would not close so I put the jumper back in for the ejector back switch and the problem went away. He pulled out the mold and I worked everything just fine with the mold out so evidently there is a problem with the ejector back switch, or he has the knockouts too loose to make the switch.?
Mp#11- started working on the circuit changes for it. I installed the 120 and 210 relays, verified the wiring on the robot/IMM interface plug. The next thing I have to do is change the wiring for the door switches, and E-stop circuit. I did not have time to get into that before they want to run it on days Friday so that is where I am with that.
Mp#25- put the belt back on the small conveyor and tracked it so it was not riding towards the loose side.
I left a PTO form for the floating holiday I have to use this month Josh.
Have a nice day.
Sean
No comments:
Post a Comment