Mp#15-had a bleedoff back about 3 bands. We cleaned it off and patched it up without replacing anything but the nozzle clamp. O.K. to run.
Mp#7- put a material loading sensor on the hopper sight glass at the request of Process Techs. Had to get one from the Turck vending machine. Used the number 00344.
Mp#23- put another 120vac receptacle at the rear of the machine per Mitch's work order request.
Robot on press # 2 - Did a pm on it. Mounted some brackets to hold the HMI touch panel securely to pendant. I still need to do one on #11 when it is down.
Robot on press#25- Also did pm. Cleaned, greased, inspected, tightened screws etc.
The single cavity topcover mold is leaking on press#11. It was pulled out with a workorder last time it ran, instead of moving it to a repair location, someone just put it back in the racks. Bill mentioned to me that it was back there with the work order, but by then it was already scheduled to go back in on our shift and run again. I asked Marty if he wanted to shut it down to fix the leak, he said no.
I did notice that many of the ISO work instructions on the Online Document website have not been revised since 2002, etc. Including the molding maintenance work order request instruction. We were looking for the procedure for mixing up the ink for the pad printer. It was not there or at the support site.
Need to order some cabinet fans like we use in the robot control panels and DME boxes. Need both 240 and 12oVAC. 3 are out in the robot panels, and I think one of the Cincinatti's has one out also. Then the DME's run on 240vac and we do not have any of those either.
Call if you need me to come in or have any questions.
Sean
No comments:
Post a Comment