Ordered new Saskawa servo amp from Nissei for MP1. Should be here 6/1/10. Called Saskawa and requested they send us our unrepaired unit and regenerative pack.
Should be here 6/1/10. Nissei is now set up to accept P.O.’s, net 30.
Set up welder ejectors on MP12 for new Edge fan housing ejector cylinders, used outputs 12 and 13, top two single valves. Firing sequence is top ejectors step 5, bottom ejectors step 6. When door open part is laying loose for operator to remove.
Changed out safety latches in hoist ring hooks in molding production area. (both hoists)
Installed additional 480 outlet on MP18. Two outlets share a 30A breaker for Thermalators.
Fabbed and installed extrusion frame to hang heater wire junction box on MP2. Mount junction box to new frame. Replace and label all heater wiring.
Install and adjust spare Robot EOAT for fan housing on MP8
Replaced (4) 2” load system hose sections up in mezzanine area with what hose we had on hand. More hose is coming. Replaced 2.5” material hose on top of surge bins. Installed elbows and partially hard piped some drops. We are trying to eliminate all vacuum leaks.
Install sand paper to the bottom of rework fixture for orbiter disks and realign.
Worked on color pump signal for MP1. Parts are here to steal a signal from the output of the servo drive to the motor.
Mark McKee
Technical Specialist
Oreck Manufacturing Company
mmckee@oreck.com
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7851
No comments:
Post a Comment