MP-22 Tech said cores not working -- found eject. back switch wasn’t made – they forgot to tie in the knock-outs.
MP-2 Mid zone heat kept dropping out; contactor was bad – replaced
MP-22 Checked torque on the screw gun for the valve body. Max torque on the SOP is 14 ; It is running 12.5 – 12.75. They had a few
parts crack . I think the parts may have just been too hot.
MP-5 One of the wheel mounting brackets on the ( small parts ) shelf unit broke off. I took it to the shop & brazed it back on.
MP-5 Getting the prefill alarm again. Changed settings & offset. It ran until right before shift change & alarmed out FHD exceeded limit.
I left it with Sean.
Cleaned up oil & changed pads on MP-17 & 21.
MP-11 The core pin broke & when they pulled the core cylinder off, they pulled the wires loose. Repaired.
PM’s on press 2 , 3 , & 4. MP-3 needs new fan in robot cabinet.
R. Upchurch
No comments:
Post a Comment