Since the mold was broken by eject retract with a part still on it. Temporarily we have changed the PLC program on press 3 with added safe guards to prevent mold from retracting the ejectors if the you do not have vacuum confirmation and there is a back check on the vacuum sensor to make sure the switch is adjusted properly. Multi-eject, Y up after eject, and eject retract before X back has been disabled. We will work on a better solution as time allows.
Mark McKee
Technical Specialist
Oreck Manufacturing Company
mmckee@oreck.com
PH 931.646.7856
CELL 931.644.5289
FAX 931.646.7615
No comments:
Post a Comment