MP-3 Replaced the mercury contactor on the front zone.
MP-6 Vacuumed oil pan – AGAIN - We have another motor & pump in the bunker – just need the time & man power to put it in.
I’ve been checking the vacuum sensors on the phaser robots- found three of them adjusted too high. They need to be setting these up for each eoat.
MP-10 I tried out the prototype part for the nut press , it looks like it will work fine.
MP-2 They hung the main frame & the core plugs were missing again. Also one of the hydraulic quick-connects was broke off, and the eject. back safety
switch wire was mashed between the mold & platen, other than that, it was in great shape.
MP-2 Small blowback- took out nozzle heater band & fuse.
MP-1 Blow back- Pulled nozzle wires apart. It had a ¾ tip on it & the mold was ½” . I thought they were going to make them all ¾ .
Power outage- Tripped the north buss breaker & shut down the compressor. Reset.
I put gear oil in MP-2,3,& 4.
MP-5 Core plugs on the mold were broken. I hard wired them in to get them going. Will change them out when they pull it.
MP-4 I had no signal from the input card for Y reference. I pulled one out of MP-3 & tried it, worked fine. I put the one I thought was bad in MP-3- It ran good.
It must have been a bad edge connection. MP-8 Core not moving—Had a bad quick connect.
MP-5 The core cylinder on the non-operator side blew a seal . I pulled the cylinder & put it in the shop. Sean was repairing it when I left.
No comments:
Post a Comment