4.8.11 D-shift Sean

Robot on #11- stopped a few times. The x-axis was giving an error. I slowed the speed value down from 11000 to 8500 and that seemed to help as it did not stop anymore through the night. Press#16- Cleared a nozzle bleed-off. Press#14- replaced a nozzle heaterband. Installed the E-stop switch lock out devices on presses#2,4,6,7,8,9,10,18,and 22. I am keeping up with them on the PM board. Bill Potter requested that Ronnie get Gil to replace the worn out section of the 14mm allen socket they use for changing molds. It is worn out. Transfered the heat treat item as directions prescribed, left it laying on the table beside the oven. Swept the shop floor once over. I will continue with Pm's tomorrow and whatever else is available for repairs pending, projects, etc. Call or email if there are any questions. Have a great day. Sean