Mp#9- Robot kept stopping, It was stopping over the conveyor every time. I noticed the speeds on the axis were all maxed out. I slowed them down to around 9800 each and it did not stop anymore afterwards.
Mp#10- Robot did not stop any at all tonight. Good Job guys!
Vacuumed oil out from under 10 also.
Mp#2- replaced nozzle heater band and fuse from bleedoff. Had to burn out the sprue plastic with oxy/acetylene torch.
Mp#16, Mp#19- PM'd.
Mp#8- Fan Housing press had problems with the nut press die magnet/ locating pin getting stuck inside the recess orifice. Took the one off the spare press and replaced it.
Left the damaged one in the shop for Gary or Mike to make a new one by...maybe?
Call if there are any questions.
Have a great day!
Sean
No comments:
Post a Comment