4.5.11 D-shift Sean

Mp#26- Worked on the robot interface some more tonight. I have it where it will run through one cycle completely but then I get an alarm for the X18 input "cycle start interlock signal not received". It doesn't appear that the cycle start signal is being received from the robot. It may just be a set-up thing. I got with Mark and he is going to look at it later. Meanwhile... Mp#21- D shift left the press down at 6 o'clock Thursday morning because the cable for the fan mold had broken and tooling was going to make up something more permanent to pull out the stripper plate. C shift left the Nylon in the barrel not purged. It stayed in there through day shift and into night shift when Bill let me know around 1:00 or 2:00 a.m. that it would not pull material through it. The material had turned into degraded hard plastic that resembled hard clay. After attempting to remove the material conventionally, maintenance began pulling the screw out of the barrel to unwrap it. Call if you have any questions. Have a nice day. Sean