3-3-11 Mike Daniels

Battled with robot on mp10 most of the weekend it would stop in random positions I checked power supplies the 12volt supply seemed a little hot but was working. Gary also checked all the connections it ran for a few more hrs then started stopping frequently again. Gary was working on it Sunday and discovered a relay that may have been bad, hasn’t missed a lick since.

 

Mp26 drilled and tapped platen and installed robot, plumbed the air in and ran cables. I believe Sean is going to finish the interfacing process.

 

Dr18 in shop. I finished putting process heaters in and installed new blower/motor there is a board lying in the rack not sure where it goes or if it’s bad as I didn’t remove it. And that’s where we are on that.

 

Worked some on PMs.

 

 

Mike Daniels

Technical Specialist

Oreck Manufacturing

1400 Salem Rd

Cookeville,  TN  38506

Cell 931.287.6252

 

Eat. Sleep. Fish.